SMD code 692K
Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.
692K on a chip resistor
692 kΩ
692 kΩ resistor
The K is both the decimal point and the multiplier: 692 kΩ.
Check it with a meter
Lift one end and measure across it. A good one reads 692 kΩ. Measuring it in circuit reads the parallel combination of everything around it, which is almost always lower, never higher: well above 692 kΩ on the board is a fault. Open, or well above 692 kΩ, means it has failed: burnt, cracked or corroded. That does not change what to fit: the marking still says 692 kΩ. A burnt resistor usually means the part it feeds drew too much, so find that before fitting a new one.
On a transistor or diode body (SOT-143, SOT-23-5), 692K is a part code instead. Those parts are listed below.
3 parts are printed 692K
Not sure which one you have?
Answer up to 4 quick questions and these 3 parts are ranked, with a meter test that settles it. It works on a dead part too.
Voltage supervisor. What differs:
G692H438T1UfSOT-23-55 pins, Global Mixed-mode TechnologySOT-23-55 pinsGlobal Mixed-mode Technology
- What it is
- Voltage supervisor
- Maker
- Global Mixed-mode Technology
- Package
- SOT-23-5
- Pins
- 5
- Details
- 4-Pin µP Voltage Monitors with Manual Reset Input
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Integrated circuit.
G692H438TCUfSOT-1434 pins, Global Mixed-mode TechnologySOT-1434 pinsGlobal Mixed-mode Technology
- What it is
- Voltage supervisor
- Maker
- Global Mixed-mode Technology
- Package
- SOT-143
- Pins
- 4
- Details
- 4-Pin µP Voltage Monitors with Manual Reset Input
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Integrated circuit.
SS8039H438TCSOT-1434 pins, Silicon StandardSOT-1434 pinsSilicon Standard
- What it is
- Voltage supervisor
- Maker
- Silicon Standard
- Package
- SOT-143
- Pins
- 4
- Details
- Voltage detector IC: 4.38V±1.5%, +Reset PPO, -MR
- Source
- Published code list
Is it dead? The meter test is below: Integrated circuit.
Is it dead? One meter test per kind
Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.
Integrated circuit
Voltage with the board powered; ohms from each pin to ground with it off.
Working, it reads
Supply pin at its voltage and the output doing what the datasheet says. Readings between pins depend on the part.
Dead, it reads
- A pin near 0 Ω to ground or to the supply pin where an identical part does not read that: failed short.
- Supply present, output stuck: failed, or its load has.
- On the board:
- A pin shorted to ground on the board can be anything on that net. Lift the pin to be sure.
- Compare:
- The surest reference is the same IC on a working board, measured pin by pin.
- Watch for:
- Its protection diodes can read like junctions between pins, even like a transistor. That proves nothing either way.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Did you find your part?
Open this in the search to correct a character or try another package.