SMD code LG
Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.
140 parts are printed LG
Not sure which one you have?
Answer up to 4 quick questions and these 50 parts are ranked, with a meter test that settles it. It works on a dead part too.
2SC2712SOT-23NPN transistor, 3 pins, Micro Commercial ComponentsNPN transistorSOT-233 pinsMicro Commercial Components
- What it is
- NPN transistor
- Maker
- Micro Commercial Components
- Package
- SOT-23
- Pins
- 3
- Details
- NPN bipolar transistor
- Source
- Published code list
Is it dead? The meter test is below: NPN transistor.
2SC2712GRSOT-233 pins, ToshibaNot recordedSOT-233 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-23
- Pins
- 3
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC3052SOT-23NPN transistor, 3 pins, GMENPN transistorSOT-233 pinsGME
- What it is
- NPN transistor
- Maker
- GME
- Package
- SOT-23
- Pins
- 3
- Source
- Published code list
Is it dead? The meter test is below: NPN transistor.
2SC4116SOT-233 pinsNot recordedSOT-233 pinsNot recorded
- What it is
- Not recorded
- Maker
- Not recorded
- Package
- SOT-23
- Pins
- 3
- Details
- npn
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC4116GRSOT-3233 pins, ToshibaNot recordedSOT-3233 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-323
- Pins
- 3
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC4154-GSOT-3233 pins, MitNot recordedSOT-3233 pinsMit
- What it is
- Not recorded
- Maker
- Mit
- Package
- SOT-323
- Pins
- 3
- Details
- Si-npn: AF-Amp, 50V, 200mA, 150mW, 200MHz, B=400..800
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC4207-GRSOT-23-55 pins, ToshibaNot recordedSOT-23-55 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-23-5
- Pins
- 5
- Details
- NPN transistor: Dual, AF, 60V, 150mA, 300mW, B=200..400, >80MHz
- Source
- Published code list
Is it dead? The meter test is below: Bipolar transistor.
2SC4207GSOT-23-55 pins, ToshibaNot recordedSOT-23-55 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-23-5
- Pins
- 5
- Details
- 2x npn gp af hfe 200-400 comp 2SA1618
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC4738-GRSOT-233 pins, ToshibaNot recordedSOT-233 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-23
- Pins
- 3
- Details
- Si-npn: AF-Amp, 60V, 150mA, 100mW, >80MHz, B=200..400
- Source
- Published code list
Is it dead? The meter test is below: This part.
2SC4944-GRSOT-23-55 pins, ToshibaNot recordedSOT-23-55 pinsToshiba
- What it is
- Not recorded
- Maker
- Toshiba
- Package
- SOT-23-5
- Pins
- 5
- Details
- NPN transistor: Dual, AF, 60V, 150mA, 200mW, B=200..400, >80MHz
- Source
- Published code list
Is it dead? The meter test is below: Bipolar transistor.
2SC5383-GSOT-4163 pins, Isahaya ElectronicsNot recordedSOT-4163 pinsIsahaya Electronics
- What it is
- Not recorded
- Maker
- Isahaya Electronics
- Package
- SOT-416
- Pins
- 3
- Details
- Si-npn: AF-Amp, 50V, 200mA, 125mW, 200MHz, B=400..800
- Source
- Published code list
Is it dead? The meter test is below: This part.
3.0SMB15ASMBZener diode, 2 pins, Ruilong Yuan ElectronicsZener diodeSMB2 pinsRuilong Yuan Electronics
- What it is
- Zener diode
- Maker
- Ruilong Yuan Electronics
- Package
- SMB
- Pins
- 2
- Details
- Zener diode: 14.40..16.50V, Zzt=5.5, Izt=50mA, 3W
- Source
- Published code list
Is it dead? The meter test is below: Zener diode.
3 more parts have no package on record
2SC4738F-GRNPN transistor, ToshibaNPN transistorNot recordedNot recordedToshiba
- What it is
- NPN transistor
- Maker
- Toshiba
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Si-npn: AF-Amp, 60V, 150mA, 100mW, >80MHz, B=200..400
- Source
- Published code list
Is it dead? The meter test is below: NPN transistor.
2SC4738FT-GRNPN transistor, ToshibaNPN transistorNot recordedNot recordedToshiba
- What it is
- NPN transistor
- Maker
- Toshiba
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Si-npn: AF-Amp, 60V, 150mA, 100mW, >80MHz, B=200..400
- Source
- Published code list
Is it dead? The meter test is below: NPN transistor.
2SC5804-GIsahaya ElectronicsNot recordedNot recordedNot recordedIsahaya Electronics
- What it is
- Not recorded
- Maker
- Isahaya Electronics
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Si-npn: AF-Amp, 50V, 200mA, 100mW, 200MHz, B=400..800
- Source
- Published code list
Is it dead? The meter test is below: This part.
Is it dead? One meter test per kind
Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.
NPN transistor
Diode range, part lifted or its base leg off the pad.
Working, it reads
Red probe on the base reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.
Dead, it reads
- Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
- The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
- Only one junction reads, or none: a junction has failed open. It then looks like a diode.
- A reading the wrong way round, where it should be open: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
This part
Diode range and ohms range, part lifted.
Working, it reads
Depends on what it is. The datasheet, or an identical part, says.
Dead, it reads
- Between two pins, the same reading both ways, near 0 V with a continuous beep: shorted.
- Open between every pair of pins: failed open, or a part that reads open when working.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Bipolar transistor
Diode range, part lifted or its base leg off the pad.
Working, it reads
From the base, one probe colour reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.
Dead, it reads
- Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
- The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
- Only one junction reads, or none: a junction has failed open. It then looks like a diode.
- A reading the wrong way round, where it should be open: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Zener diode
Diode range for the forward check, part lifted, red probe on the anode. A bench supply for the Zener voltage.
Working, it reads
About 0.6 to 0.8 V forward and open in reverse on the diode range. Its Zener voltage shows only on a supply: feed it through a resistor that sets about 5 mA, cathode to positive, read quickly, and it should hold near its rated voltage.
Dead, it reads
- The same reading both ways round, near 0 V with a continuous beep or the same middling value: shorted.
- Open both ways, forward too: failed open.
- Holds well off its rated voltage on the supply test: drifted.
- A soft knee, or a voltage that creeps on the supply test: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A meter's diode range stops at about 2 to 3 V, so almost every Zener reads open in reverse on it, good or bad; a 3 V meter may just show a 2.4 or 2.7 V part. Above about 3 V the meter cannot tell a Zener from a plain diode.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Did you find your part?
Open this in the search to correct a character or try another package.