SMD code SKs
Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.
The last letter, s, is lower case, which on NXP and Philips parts is a date or factory code, so it was set aside and SK was searched.
99 parts are printed SKs
Not sure which one you have?
Answer up to 4 quick questions and these 50 parts are ranked, with a meter test that settles it. It works on a dead part too.
S1KSMARectifier, 2 pins, General Semiconductor IndustriesRectifierSMA2 pinsGeneral Semiconductor Industries
- What it is
- Rectifier
- Maker
- General Semiconductor Industries
- Package
- SMA
- Pins
- 2
- Details
- Diode: Rectifier, 800V, 1A, Vf<1.1V(1A)
- Source
- Published code list
Is it dead? The meter test is below: Silicon diode.
S2KSMBRectifier, 2 pins, VishayRectifierSMB2 pinsVishay
- What it is
- Rectifier
- Maker
- Vishay
- Package
- SMB
- Pins
- 2
- Details
- Diode: Rectifier, 800V, 1.5A, Vf<1.15V(1.5A)
- Source
- Published code list
Is it dead? The meter test is below: Silicon diode.
S3KSMCRectifier, 2 pins, VishayRectifierSMC2 pinsVishay
- What it is
- Rectifier
- Maker
- Vishay
- Package
- SMC
- Pins
- 2
- Details
- Diode: Rectifier, 800V, 3A, Vf<1.15V(2.5A)
- Source
- Published code list
Is it dead? The meter test is below: Silicon diode.
SB1003M3SOT-233 pins, onsemiNot recordedSOT-233 pinsonsemi
- What it is
- Not recorded
- Maker
- onsemi
- Package
- SOT-23
- Pins
- 3
- Details
- Schottky rect 30V 1A
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101AWSOD-123Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-1232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-123
- Pins
- 2
- Details
- Schottky diode, 60 V, 0.015 A
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101AWSSOD-323Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-3232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-323
- Pins
- 2
- Details
- 0.015A, 60V, Surface Mount Small Signal Schottky Diodes
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101BWSOD-123Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-1232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-123
- Pins
- 2
- Details
- Schottky diode, 50 V, 0.015 A
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101BWSSOD-323Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-3232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-323
- Pins
- 2
- Details
- 0.015A, 50V, Surface Mount Small Signal Schottky Diodes
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101CWSOD-123Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-1232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-123
- Pins
- 2
- Details
- Schottky diode, 40 V, 0.015 A
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SD101CWSSOD-323Schottky diode, 2 pins, Diodes IncorporatedSchottky diodeSOD-3232 pinsDiodes Incorporated
- What it is
- Schottky diode
- Maker
- Diodes Incorporated
- Package
- SOD-323
- Pins
- 2
- Details
- 0.015A, 40V, Surface Mount Small Signal Schottky Diodes
- Source
- Published code list
Is it dead? The meter test is below: Schottky diode.
SMAJ130AGSMATVS diode, 2 pins, First SemiconductorTVS diodeSMA2 pinsFirst Semiconductor
- What it is
- TVS diode
- Maker
- First Semiconductor
- Package
- SMA
- Pins
- 2
- Details
- Transient voltage supressor: Vrwm=130V, Vbr=144..165.5V, Ipp=1.9A, 400W(1ms)
- Source
- Published code list
Is it dead? The meter test is below: TVS or ESD protection diode.
SMBTA93SOT-23PNP transistor, 3 pins, InfineonPNP transistorSOT-233 pinsInfineon
- What it is
- PNP transistor
- Maker
- Infineon
- Package
- SOT-23
- Pins
- 3
- Details
- Si-pnp: Vid, 200/200V, 500mA, 330mW, B=25, >50MHz
- Source
- Published code list
Is it dead? The meter test is below: PNP transistor.
3 more parts have no package on record
S1PKRectifier, VishayRectifierNot recordedNot recordedVishay
- What it is
- Rectifier
- Maker
- Vishay
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Diode: Rectifier, 800V, 1A, Vf<1.1V(1A)
- Source
- Published code list
Is it dead? The meter test is below: Silicon diode.
SMAS130ATVS diode, Formosa MicrosemiTVS diodeNot recordedNot recordedFormosa Microsemi
- What it is
- TVS diode
- Maker
- Formosa Microsemi
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Transient voltage supressor: Vrwm=130V, Vbr=144..159V, Ipp=1.9A, 400W(1ms)
- Source
- Published code list
Is it dead? The meter test is below: TVS or ESD protection diode.
SMF4L130AQTVS diode, Diodes IncorporatedTVS diodeNot recordedNot recordedDiodes Incorporated
- What it is
- TVS diode
- Maker
- Diodes Incorporated
- Package
- Not recorded
- Pins
- Not recorded
- Details
- Transient voltage supressor: Vrwm=130V, Vbr=144..159V, Ipp=1.9A, 400W(1ms)
- Source
- Published code list
Is it dead? The meter test is below: TVS or ESD protection diode.
Is it dead? One meter test per kind
Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.
Silicon diode
Diode range, part lifted or one leg off the pad. Red probe on the anode.
Working, it reads
About 0.5 to 0.8 V anode to cathode, and open the other way. Small switching diodes read about 0.6 to 0.7 V; large rectifiers can read a little lower.
Dead, it reads
- The same reading both ways round, near 0 V with a continuous beep or the same middling value: shorted.
- Open both ways: failed open.
- A reading the wrong way round as well: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A three-pin body can hold two diodes. With a common pin they read two junctions from that pin, just like a transistor; in series they read two drops end to end. Test each pair the datasheet names.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Schottky diode
Diode range, part lifted or one leg off the pad. Red probe on the anode.
Working, it reads
About 0.15 to 0.45 V anode to cathode, roughly half a silicon diode, and open the other way.
Dead, it reads
- The same reading both ways round, near 0 V with a continuous beep or the same middling value: shorted.
- A reading the wrong way round as well: leaky.
- Open both ways: failed open.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A large Schottky can read about 0.1 V forward and beep like a short, and leaks a little the wrong way when good, more when warm. It is shorted only if it reads the same both ways. Measure it cold, beside an identical cold one.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
TVS or ESD protection diode
Diode range, from the protected line to ground, part lifted if you can.
Working, it reads
A one-way part reads about 0.6 to 0.8 V forward and open in reverse. A two-way part reads open both ways. Arrays with several lines read as the datasheet's diagram draws them.
Dead, it reads
- From the line to ground, the same reading both ways, near 0 V with a continuous beep: shorted.
- A reading both ways on a one-way part: leaky.
- A one-way part open both ways: failed open.
- On the board
- , a line reading shorted to ground can be this part or anything else on that line. Lift it: if the short goes with it, it has failed.
- Compare:
- The same part on the next line or connector pin is the healthy reading to compare with.
- Watch for:
- A two-way part reads open both ways when it is good, exactly like one that has failed open. The meter cannot tell them apart; an identical part on the next line can.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
PNP transistor
Diode range, part lifted or its base leg off the pad.
Working, it reads
Black probe on the base reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.
Dead, it reads
- Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
- The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
- Only one junction reads, or none: a junction has failed open. It then looks like a diode.
- A reading the wrong way round, where it should be open: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Did you find your part?
Open this in the search to correct a character or try another package.