Skip to content

SMD code T2B

Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.

Not sure which one you have?

Answer up to 4 quick questions and these 12 parts are ranked, with a meter test that settles it. It works on a dead part too.

  • LM20BIM7SOT-353Temperature sensor, 5 pins, Texas InstrumentsTemperature sensorSOT-3535 pinsTexas Instruments
    What it is
    Temperature sensor
    Maker
    Texas Instruments
    Package
    SOT-353
    Pins
    5
    Details
    2.4-V, 10-µA, SC70, DSBGA Temperature Sensor
    Source
    Manufacturer datasheet

    Is it dead? The meter test is below: Integrated circuit.

  • LM20BIM7XSOT-353Temperature sensor, 5 pins, Texas InstrumentsTemperature sensorSOT-3535 pinsTexas Instruments
    What it is
    Temperature sensor
    Maker
    Texas Instruments
    Package
    SOT-353
    Pins
    5
    Details
    2.4-V, 10-µA, SC70, DSBGA Temperature Sensor
    Source
    Manufacturer datasheet

    Is it dead? The meter test is below: Integrated circuit.

  • PJT7872BSOT-363MOSFET, 6 pins, PanjitMOSFETSOT-3636 pinsPanjit
    What it is
    MOSFET
    Maker
    Panjit
    Package
    SOT-363
    Pins
    6
    Source
    Manufacturer datasheet

    Is it dead? The meter test is below: MOSFET.

  • ADT6502SRJZP095RL7SOT-23-55 pins, Analog DevicesNot recordedSOT-23-55 pinsAnalog Devices
    What it is
    Not recorded
    Maker
    Analog Devices
    Package
    SOT-23-5
    Pins
    5
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • PMBT2907SOT-23PNP transistor, 3 pins, NXPPNP transistorSOT-233 pinsNXP
    What it is
    PNP transistor
    Maker
    NXP
    Package
    SOT-23
    Pins
    3
    Details
    40V, 600 mA, PNP switching transistor
    Source
    Published code list

    Is it dead? The meter test is below: PNP transistor.

  • XC9148B29DER-GUSP-6CDC-DC converter, 6 pins, TorexDC-DC converterUSP-6C6 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    USP-6C
    Pins
    6
    Details
    DC/DC voltage converter IC: PWM/PFM st-up, 3.0MHz, 2.9V±2%, 1.4A, CrL, I-O-Bps, +CE
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • XC9148B29DPR-GSOT-89-5DC-DC converter, 5 pins, TorexDC-DC converterSOT-89-55 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    SOT-89-5
    Pins
    5
    Details
    DC/DC voltage converter IC: PWM/PFM step-up, 3.0MHz, 2.9V±2%, 1.4A, CrL, I-O-Bps, +CE
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • XC9225A21CMSOT-23-5DC-DC converter, 5 pins, TorexDC-DC converterSOT-23-55 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    SOT-23-5
    Pins
    5
    Details
    DC/DC voltage converter IC: PWM st-dwn, 1.2MHz, 2.1V±1%, 600mA, +CE
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • XC9225B21CMSOT-23-5DC-DC converter, 5 pins, TorexDC-DC converterSOT-23-55 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    SOT-23-5
    Pins
    5
    Details
    DC/DC voltage converter IC: PWM st-dwn, 1.2MHz, 2.1V±1%, 600mA, -CE
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • XC9225C21CMSOT-23-5DC-DC converter, 5 pins, TorexDC-DC converterSOT-23-55 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    SOT-23-5
    Pins
    5
    Details
    DC/DC voltage converter IC: PWM st-dwn, 1.2MHz, 2.1V±1%, 600mA, +CE, PDR
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • XC9225D21CMSOT-23-5DC-DC converter, 5 pins, TorexDC-DC converterSOT-23-55 pinsTorex
    What it is
    DC-DC converter
    Maker
    Torex
    Package
    SOT-23-5
    Pins
    5
    Details
    DC/DC voltage converter IC: PWM st-dwn, 1.2MHz, 2.1V±1%, 600mA, -CE, PUR
    Source
    Published code list

    Is it dead? The meter test is below: Integrated circuit.

  • ZUMT860BSOT-323PNP transistor, 3 pinsPNP transistorSOT-3233 pinsNot recorded
    What it is
    PNP transistor
    Maker
    Not recorded
    Package
    SOT-323
    Pins
    3
    Source
    Published code list

    Is it dead? The meter test is below: PNP transistor.

Is it dead? One meter test per kind

Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.

Integrated circuit

Voltage with the board powered; ohms from each pin to ground with it off.

Working, it reads

Supply pin at its voltage and the output doing what the datasheet says. Readings between pins depend on the part.

Dead, it reads

  • A pin near 0 Ω to ground or to the supply pin where an identical part does not read that: failed short.
  • Supply present, output stuck: failed, or its load has.
On the board:
A pin shorted to ground on the board can be anything on that net. Lift the pin to be sure.
Compare:
The surest reference is the same IC on a working board, measured pin by pin.
Watch for:
Its protection diodes can read like junctions between pins, even like a transistor. That proves nothing either way.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

MOSFET

Diode range, part lifted. Test drain to source first, then short gate to source and test again.

Working, it reads

One way between drain and source reads about 0.4 to 0.9 V, the body diode, and the other way open. The gate reads open to both other pins.

Dead, it reads

  • Drain to source the same both ways, near 0 V with a continuous beep, and still so after shorting gate to source: shorted. The classic failure.
  • The gate reads low to source or drain: gate shorted.
  • No body diode at all: failed open.
On the board
the gate usually has a resistor to the source, which reads as that resistor and is not a fault. Lift a leg to be sure.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
Watch for:
The diode range can charge the gate enough to turn the part on, and then drain to source reads near 0 both ways on a good part. Short gate to source and test again before you condemn it.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

This part

Diode range and ohms range, part lifted.

Working, it reads

Depends on what it is. The datasheet, or an identical part, says.

Dead, it reads

  • Between two pins, the same reading both ways, near 0 V with a continuous beep: shorted.
  • Open between every pair of pins: failed open, or a part that reads open when working.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

PNP transistor

Diode range, part lifted or its base leg off the pad.

Working, it reads

Black probe on the base reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.

Dead, it reads

  • Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
  • The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
  • Only one junction reads, or none: a junction has failed open. It then looks like a diode.
  • A reading the wrong way round, where it should be open: leaky.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
Watch for:
A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

Printed with a code easy to misread as T2B

One character differs, and it is one that is easy to confuse under a lamp. Each code has a page of its own.

Codes that begin with T2B

For a marking with its end worn or burnt off. Each code has a page of its own.

Codes not listed here are printed on 44 more parts.

Did you find your part?

Open this in the search to correct a character or try another package.