Skip to content

SMD code TR-

Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.

62 parts are printed TR-

Not sure which one you have?

Answer up to 4 quick questions and these 50 parts are ranked, with a meter test that settles it. It works on a dead part too.

  • TV02W171-HFSOD-123FTVS diode, 2 pins, ComchipTVS diodeSOD-123F2 pinsComchip
    What it is
    TVS diode
    Maker
    Comchip
    Package
    SOD-123F
    Pins
    2
    Details
    170 V 200 W unidirectional TVS diode
    Source
    Manufacturer datasheet

    Is it dead? The meter test is below: TVS or ESD protection diode.

  • UMD2NSOT-363Digital transistor (resistors built in), 6 pins, Galaxy MicroelectronicsDigital transistor (resistors built in)SOT-3636 pinsGalaxy Microelectronics
    What it is
    Digital transistor (resistors built in)
    Maker
    Galaxy Microelectronics
    Package
    SOT-363
    Pins
    6
    Details
    50V, 30mA, NPN Bipolar Digital Transistor 50V, 30mA, PNP Bipolar Digital Transistor
    Source
    Manufacturer datasheet

    Is it dead? The meter test is below: Digital transistor.

  • 1SMA75AT3GSMATVS diode, 2 pins, onsemiTVS diodeSMA2 pinsonsemi
    What it is
    TVS diode
    Maker
    onsemi
    Package
    SMA
    Pins
    2
    Details
    75V Uni-Directional TVS Diode
    Source
    Published code list

    Is it dead? The meter test is below: TVS or ESD protection diode.

  • 2SA1530A-RSOT-233 pins, PanNot recordedSOT-233 pinsPan
    What it is
    Not recorded
    Maker
    Pan
    Package
    SOT-23
    Pins
    3
    Details
    Si-pnp: AF, 60V, 150mA, 200mW, B=180..390, 200MHz
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 2SA1603-RSOT-3233 pins, MitNot recordedSOT-3233 pinsMit
    What it is
    Not recorded
    Maker
    Mit
    Package
    SOT-323
    Pins
    3
    Details
    Si-pnp: AF, 50V, 100mA, 150mW, 200MHz, B=180..390
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 2SA1989-RSOT-4163 pins, MitNot recordedSOT-4163 pinsMit
    What it is
    Not recorded
    Maker
    Mit
    Package
    SOT-416
    Pins
    3
    Details
    Si-pnp: AF, 50V, 100mA, 150mW, B=180..390, 200MHz
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 2SC2406SOT-23NPN transistor, 3 pins, PanasonicNPN transistorSOT-233 pinsPanasonic
    What it is
    NPN transistor
    Maker
    Panasonic
    Package
    SOT-23
    Pins
    3
    Source
    Published code list

    Is it dead? The meter test is below: NPN transistor.

  • 2SC2406-RSOT-233 pins, PanNot recordedSOT-233 pinsPan
    What it is
    Not recorded
    Maker
    Pan
    Package
    SOT-23
    Pins
    3
    Details
    Si-npn: AF, LN, 55V, 10mA, 200mW, B=180..360, 200MHz
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 2SC3906K-RSOT-23NPN transistor, 3 pins, ROHMNPN transistorSOT-233 pinsROHM
    What it is
    NPN transistor
    Maker
    ROHM
    Package
    SOT-23
    Pins
    3
    Details
    Si-npn: AF-Drv, 120V, 50mA, 200mW, B=390..820, 140MHz
    Source
    Published code list

    Is it dead? The meter test is below: NPN transistor.

  • 2SC3906KRSOT-233 pins, ROHMNot recordedSOT-233 pinsROHM
    What it is
    Not recorded
    Maker
    ROHM
    Package
    SOT-23
    Pins
    3
    Details
    equivalent 2SC2389SR
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 2SC3929ASOT-323NPN transistor, 3 pins, PanasonicNPN transistorSOT-3233 pinsPanasonic
    What it is
    NPN transistor
    Maker
    Panasonic
    Package
    SOT-323
    Pins
    3
    Source
    Published code list

    Is it dead? The meter test is below: NPN transistor.

  • 2SC3929A-RSOT-3233 pins, PanNot recordedSOT-3233 pinsPan
    What it is
    Not recorded
    Maker
    Pan
    Package
    SOT-323
    Pins
    3
    Details
    Si-npn: AF, LN, 55V, 50mA, 150mW, B=180..360, 80MHz
    Source
    Published code list

    Is it dead? The meter test is below: This part.

  • 3 more parts have no package on record
    • 1SMA75ATVS diode, onsemiTVS diodeNot recordedNot recordedonsemi
      What it is
      TVS diode
      Maker
      onsemi
      Package
      Not recorded
      Pins
      Not recorded
      Details
      TVS: 75V±5%, 3.3A, 400W (1ms)
      Source
      Published code list

      Is it dead? The meter test is below: TVS or ESD protection diode.

    • 2SA1530APNP transistorPNP transistorNot recordedNot recordedNot recorded
      What it is
      PNP transistor
      Maker
      Not recorded
      Package
      Not recorded
      Pins
      Not recorded
      Source
      Published code list

      Is it dead? The meter test is below: PNP transistor.

    • 2SC4102NPN transistorNPN transistorNot recordedNot recordedNot recorded
      What it is
      NPN transistor
      Maker
      Not recorded
      Package
      Not recorded
      Pins
      Not recorded
      Details
      NPN High-Voltage Amplifier Transistor
      Source
      Published code list

      Is it dead? The meter test is below: NPN transistor.

Is it dead? One meter test per kind

Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.

TVS or ESD protection diode

Diode range, from the protected line to ground, part lifted if you can.

Working, it reads

A one-way part reads about 0.6 to 0.8 V forward and open in reverse. A two-way part reads open both ways. Arrays with several lines read as the datasheet's diagram draws them.

Dead, it reads

  • From the line to ground, the same reading both ways, near 0 V with a continuous beep: shorted.
  • A reading both ways on a one-way part: leaky.
  • A one-way part open both ways: failed open.
On the board
, a line reading shorted to ground can be this part or anything else on that line. Lift it: if the short goes with it, it has failed.
Compare:
The same part on the next line or connector pin is the healthy reading to compare with.
Watch for:
A two-way part reads open both ways when it is good, exactly like one that has failed open. The meter cannot tell them apart; an identical part on the next line can.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

Digital transistor

Ohms range, part lifted. The datasheet gives the built-in resistors: R1 in series with the base, R2 from base to emitter.

Working, it reads

Base to emitter reads about R1 plus R2 either way round, about 20 kΩ on a 10 k and 10 k part, give or take their wide tolerance. Collector to emitter reads open. A part with no R2 reads a junction behind R1 one way instead.

Dead, it reads

  • Collector to emitter the same both ways, near 0 Ω with a continuous beep: shorted.
  • From the base, open or far above R1 plus R2: R1 has failed. Static damage shows here most often.
  • Base to emitter near 0 Ω: failed short.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
The readings depend on the resistor values, so an identical part elsewhere on the board is the surest reference. Measure it the same way.
Watch for:
On the diode range a good part with 10 kΩ resistors reads open on every pair, so a good part looks dead there. Use the ohms range.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

PNP transistor

Diode range, part lifted or its base leg off the pad.

Working, it reads

Black probe on the base reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.

Dead, it reads

  • Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
  • The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
  • Only one junction reads, or none: a junction has failed open. It then looks like a diode.
  • A reading the wrong way round, where it should be open: leaky.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
Watch for:
A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

This part

Diode range and ohms range, part lifted.

Working, it reads

Depends on what it is. The datasheet, or an identical part, says.

Dead, it reads

  • Between two pins, the same reading both ways, near 0 V with a continuous beep: shorted.
  • Open between every pair of pins: failed open, or a part that reads open when working.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

NPN transistor

Diode range, part lifted or its base leg off the pad.

Working, it reads

Red probe on the base reads about 0.6 to 0.75 V to the emitter and to the collector, and open the other way round. Collector to emitter reads open both ways.

Dead, it reads

  • Collector to emitter the same both ways, near 0 V with a continuous beep: shorted. The commonest failure.
  • The base the same both ways to another pin, near 0 V or a middling value: a shorted junction.
  • Only one junction reads, or none: a junction has failed open. It then looks like a diode.
  • A reading the wrong way round, where it should be open: leaky.
On the board
this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
Compare:
If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
Watch for:
A pair of diodes with a common pin reads just like a transistor, and some transistors carry a built-in diode or resistor. The datasheet says which.

A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.

Did you find your part?

Open this in the search to correct a character or try another package.