SMD code S1D in SMA
Marking codes are not standardised, and the same code is reused by unrelated makers for unrelated parts. Below is every part in our tables printed with it, and any printed with a code that is easy to misread as it, from the manufacturers' own marking tables and published code lists.
4 parts in SMA are printed S1D
Not sure which one you have?
Answer up to 4 quick questions and these 5 parts are ranked, with a meter test that settles it. It works on a dead part too.
AS1D-HFSMARectifier, 2 pins, ComchipRectifier2 pinsComchip
- What it is
- Rectifier
- Maker
- Comchip
- Package
- SMA
- Pins
- 2
- Details
- 200 V, 1 A rectifier
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Silicon diode.
S1D-HFSMARectifier, 2 pins, ComchipRectifier2 pinsComchip
- What it is
- Rectifier
- Maker
- Comchip
- Package
- SMA
- Pins
- 2
- Details
- 200 V, 1 A rectifier
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Silicon diode.
TS1DSMARectifier, 2 pins, Galaxy MicroelectronicsRectifier2 pinsGalaxy Microelectronics
- What it is
- Rectifier
- Maker
- Galaxy Microelectronics
- Package
- SMA
- Pins
- 2
- Details
- 1A, 200V, Surface Mount Standard Recovery Rectifiers
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Silicon diode.
DRS1DSMA2 pins, LRCNot recorded2 pinsLRC
- What it is
- Not recorded
- Maker
- LRC
- Package
- SMA
- Pins
- 2
- Details
- Diode: Fast recov. rectif, 200V, 1A, Vf<1.3V(1A), <150ns
- Source
- Published code list
Is it dead? The meter test is below: Silicon diode.
1 more part has no package on record. Nothing rules it out, so it stays.
S10DHERectifier, Galaxy MicroelectronicsRectifierNot recordedGalaxy Microelectronics
- What it is
- Rectifier
- Maker
- Galaxy Microelectronics
- Package
- Not recorded
- Pins
- Not recorded
- Details
- 1A, 200V, Surface Mount Standard Recovery Rectifiers
- Source
- Manufacturer datasheet
Is it dead? The meter test is below: Silicon diode.
Is it dead? One meter test per kind
Parts of the same kind are tested the same way, so each test is here once. Each part above points to its own.
Silicon diode
Diode range, part lifted or one leg off the pad. Red probe on the anode.
Working, it reads
About 0.5 to 0.8 V anode to cathode, and open the other way. Small switching diodes read about 0.6 to 0.7 V; large rectifiers can read a little lower.
Dead, it reads
- The same reading both ways round, near 0 V with a continuous beep or the same middling value: shorted.
- Open both ways: failed open.
- A reading the wrong way round as well: leaky.
- On the board
- this is a first look only: the meter reads every path between those pins, and a short can be a neighbour. Lift one leg before you condemn it.
- Compare:
- If an identical part sits elsewhere on the board, measure it the same way: that is what this one should read.
- Watch for:
- A three-pin body can hold two diodes. With a common pin they read two junctions from that pin, just like a transistor; in series they read two drops end to end. Test each pair the datasheet names.
A dead part still carries its marking. A short or an open says it has failed, not that it is a different part.
Printed with a code easy to misread as S1D
One character differs, and it is one that is easy to confuse under a lamp. Each code has a page of its own.
Codes that begin with S1D
For a marking with its end worn or burnt off. Each code has a page of its own.
Codes not listed here are printed on 32 more parts.
Did you find your part?
Open this in the search to correct a character or try another package.